Antique Baby Doll Carriage - How to Make a Baby Carriage
A Baby Carriage than that shown in Fig. 299, with its rounded ends, arched bottom, and adjustable hood?
It is easy to make.
Figure 300 shows the details for constructing the carriage body.
Cut four wooden pegs to fit loosely in the holes of four spools of equal size, and make them of the right length so when slipped into the holes their ends will project about ¼ inch beyond the spool ends.
Then cut the bottom strip B 5 inches long by the width of the spools, bend it slightly as shown, to give a curve to the carriage bottom, and tack the ends of the strip to two of the spools (A).
Fig. 299.—Doll Carriage - antique baby carriage.
Figs. 300-302.—Details of Doll Carriage - antique baby carriage.The sides C are of cardboard and should be 1½ inches wide at the widest point, by the length of the carriage body.
Punch holes through these side pieces in the right places for the ends of the pegs in spools A to stick through.
Before fastening the side pieces to spools A, you must attach the wheels (Figs. 301 and 302).
Cut the cardboard uprights D 3½ inches long and ½ inch wide; then after cutting holes through each near the ends, for the spool pegs to slip through, cut down the width between the holes to about ¼ inch (Fig. 302).
Slip the lower ends of uprights D over the pegs in spool wheels E, then the upper ends over the pegs in spools A.
Glue the upper ends to the ends of spools A, then slip the carriage sides C over the pegs of spools A, and glue them in place.
Fig. 303.—Baby Carriage Hood - antique baby carriage.
Fig. 304.—Diagram of Hood - antique baby carriage.
Fig. 305.—Carriage Handles - antique baby carriage.
The carriage hood (Fig. 303) is made of a piece of stiff paper about 4½ inches square (Fig. 304), slashed in three places along two opposite edges for a distance of about 1½ inches, and then folded over as indicated by dotted lines.
Bring together the ends of the slashed edges of the piece of paper, as shown in Fig. 303, coat them with glue, and press together until the glue has dried.
Punch a hole through each side of the top, as shown, for the projecting ends of the spool peg to slip through.
The carriage handle is made of two cardboard strips (F, Fig. 305), and a match (G). Stick the match through holes made near the ends of strips F, and glue the lower ends of the strips to the inside face of the sides (Fig. 299).
This completes the carriage.
Social Plugin